[CA11] Verifying NMEA cable function

Thread Rating:

0 Vote(s) - 0 Average
1
2
3
4
5

Threaded Mode | Linear Mode

[CA] [CA11] Verifying NMEA cable function - AIS not communicating

03-25-19, 10:12 AM

Post: #8

Chuck - Raymarine - Moderator Offline

Administrator

Posts: 14,319
Joined: Oct 2014
Reputation: 43

RE: [CA11] Verifying NMEA cable function - AIS not communicating

Andy,

As you have suggested, the AIS Dangerous Target Alarm appears to have been configured OFF. Please additionally note, that the NMEA 0183 port of any MFD (not just the Data Master MFD) is active within the system. The AIS receiver should only be interfaced to one of these MFDs. Alternatively, should the AIS receiver be interfaced to both MFDs, then the NMEA 0183 port of only one of the MFDs should be configured to "AIS 38400" whenever both MFDs are switched ON.

« Next Oldest | Next Newest »

Messages In This Thread

[CA11] Verifying NMEA cable function - AIS not communicating - andyschoenb - 03-17-19, 05:26 PM

RE: [CA11] Verifying NMEA cable function - AIS not communicating - Chuck - Raymarine - Moderator - 03-19-19, 02:00 PM

RE: [CA11] Verifying NMEA cable function - AIS not communicating - andyschoenb - 03-19-19, 06:38 PM

RE: [CA11] Verifying NMEA cable function - AIS not communicating - Chuck - Raymarine - Moderator - 03-20-19, 07:45 AM

RE: [CA11] Verifying NMEA cable function - AIS not communicating - andyschoenb - 03-20-19, 07:30 PM

RE: [CA11] Verifying NMEA cable function - AIS not communicating - Chuck - Raymarine - Moderator - 03-21-19, 12:34 PM

RE: [CA11] Verifying NMEA cable function - AIS not communicating - andyschoenb - 03-22-19, 06:25 AM

RE: [CA11] Verifying NMEA cable function - AIS not communicating - Chuck - Raymarine - Moderator - 03-25-19 10:12 AM

User(s) browsing this thread: 1 Guest(s)