The following warnings occurred:
Warning [2] count(): Parameter must be an array or an object that implements Countable - Line: 802 - File: showthread.php PHP 7.4.33 (Linux)
File Line Function
/showthread.php 802 errorHandler->error




Raymarine forum / Raymarine Forums / Autopilots v / [CA] [CA11] ST6002 and 400G AST system

Post Reply 
 
Thread Rating:
  • 0 Vote(s) - 0 Average
  • 1
  • 2
  • 3
  • 4
  • 5
[CA] [CA11] ST6002 and 400G AST system
04-17-19, 09:34 AM (This post was last modified: 04-22-19 02:36 PM by Chuck - Raymarine - Moderator.)
Post: #1
Deekay911 Offline
Junior Member
**
 		Posts: 2
Joined: Apr 2019
Reputation: 0
[CA11] ST6002 and 400G AST system
Hi, I bought a boat recently with the ST6002 and 400G AST course computer autopilot. I believed it to be working, but it has an issue. After a couple of minutes on auto, the boat's heading clearly starts to wander and after a short while the ST6002 beeps and shows 'STOPPED' and returns to standby. I tried doing the sea calibration but that didn't help at all. I know this is an old system now, but you still see plenty of these around working great. I am tempted to buy a course computer on ebay for $500 and swap it out to see if that is where the problem lies, maybe even the head.

Any clues on how to troubleshoot this, or isolate a component? If i bite the bullet and scrap the system, is there any upgrade path that could keep some of the existing setup, say the wiring, the rudder drive motor (hydraulic), rudder sensor etc?

Any comments would be most welcome! Thanks!
Find all posts by this user
Quote this message in a reply
Post Reply 


Messages In This Thread
[CA11] ST6002 and 400G AST system - Deekay911 - 04-17-19 09:34 AM

Forum Jump:


User(s) browsing this thread: 1 Guest(s)

Contact Us | Raymarine forum | Return to Top | Return to Content | Lite (Archive) Mode | RSS Syndication