[TG] [TG11] Integrating es75 MFD with ST5000+ autopilot
|
04-21-19, 03:40 AM
(This post was last modified: 04-23-19 12:40 PM by Chuck - Raymarine - Moderator.)
Post: #1
|
|||
|
|||
[TG11] Integrating es75 MFD with ST5000+ autopilot
I have a ST5000+ autopilot and have recently installed an eS75 MFD (running lighthouse II version 19.03). The units are connected via a seatalk to seatalkng converter (software 2.03).
I can use the MFD to control the pilot using the Pilot Control, switching between Standby and Auto but when in Auto mode I cannot ‘Adjust the current locked heading’. When the Pilot Control dialog (Auto) is displayed on the MFD the following are shown: 1. Pilot status 3. Rudder bar 4. Standby 5. Current locked heading 8. Close However the following are missing: 2. Left Arrow 6. Track 7. Right Arrow Please see attached photo. Any suggestions how I can get the arrows to show? Thanks. |
|||
« Next Oldest | Next Newest »
|
Messages In This Thread |
[TG11] Integrating es75 MFD with ST5000+ autopilot - RobNZL - 04-21-19 03:40 AM
RE: [TG11] Integrating es75 MFD with ST5000+ autopilot - Tom - Raymarine - Moderator - 04-30-19, 10:01 PM
|
User(s) browsing this thread: 1 Guest(s)