[CA] [CA11] Smart Pilot melted 2A fuse, blown board

[rickgard]

Dear Chuck,
I installed the used Smart Pilot i found online. Initial testing is GOOD. Pilot works at the dock, the rudder responds and rudder indicator shiws up everywhere on network. The new board is missing one component compared to old board: small extra board sitting ip on spacers. Kionix Inc. KGMGDEA01R01
It connects to the main board buy a three wire jumper with a plug on the end. The three wire connector goes through a ferrite. On the board the red is labeled +5 the black GMD yellow out. Like a seatalk.

Should I connect the old Kionix to my new smart pilot? It looks unblemished and was nowhere near the current surge that destroyed the board.
I have a close up picture of the component if it would help you to identify it.
Once again, I am very grateful for any help or direction where I could look for information for this.

Further to my last post on the Kionix component— both boards and other components are identical 4538-001.

Only difference I can see, my original board is a 3015-286 issue F, whike new board is 3015-286 issue D

Chuck - I found the the Kionix KGF01 is a gyro accelerometer - I would guess that I can take the component from my old board Type F and install on the replacement board Type D. the connector pins match and the attachment point is the same.

and I can tell the replacement Type D board had the component and the pilferer broke the housing screw attachment point in the process.