[DG11] CR hydraulic drive versus Type 3 linear hydraulic

Thread Rating:

0 Vote(s) - 0 Average
1
2
3
4
5

Threaded Mode | Linear Mode

[DG] [DG11] CR hydraulic drive versus Type 3 linear hydraulic

09-27-19, 07:58 AM (This post was last modified: 09-27-19 11:00 AM by Chuck - Raymarine - Moderator.)

Post: #3

shparrot Offline

Junior Member

Posts: 16
Joined: Oct 2018
Reputation: 0

RE: [DG11] CR hydraulic drive versus Type 3 linear hydraulic

Thanks Derek
After the initial installation, I connected a separate transducer to each ACU. Could I have damaged anything in the ACU's? They were never live at the same time.
I'm going to move the rudder transducers so they read from the tiller arms rather than the quadrant. I strongly doubt it, there might be some torquing between the arms and quadrant.

« Next Oldest | Next Newest »

Messages In This Thread

[DG11] CR hydraulic drive versus Type 3 linear hydraulic - shparrot - 09-25-19, 08:40 AM

RE: [DG11] CR hydraulic drive versus Type 3 linear hydraulic - Derek - Raymarine - Moderator - 09-26-19, 04:11 AM

RE: [DG11] CR hydraulic drive versus Type 3 linear hydraulic - shparrot - 09-27-19 07:58 AM

RE: [DG11] CR hydraulic drive versus Type 3 linear hydraulic - Derek - Raymarine - Moderator - 09-30-19, 07:04 AM

User(s) browsing this thread: 1 Guest(s)