Post Reply 
 
Thread Rating:
  • 0 Vote(s) - 0 Average
  • 1
  • 2
  • 3
  • 4
  • 5
[CA] [CA11] Hard over time on evolution wheel pilot
10-21-19, 10:04 AM
Post: #2
RE: [CA11] Hard over time on evolution wheel pilot
Welcome back to the Raymarine Forum Mark,

In actuality, the hard over time is defaulted to ten seconds and rarely needs to be changed. However, should one desire to determine hard over time then while the vessel is tied to the dock, turn the wheel hard over in one direction. Next, drive it to the other stop by applying 12VDC or 24VDC (depending on the model of drive) to the drive's motor leads while monitoring the amount of time required to reach hard over.
Visit this user's website Find all posts by this user
Quote this message in a reply
Post Reply 


Messages In This Thread
RE: [CA11] Hard over time on evolution wheel pilot - Chuck - Raymarine - Moderator - 10-21-19 10:04 AM

Forum Jump:


User(s) browsing this thread: 1 Guest(s)