Post Reply 
 
Thread Rating:
  • 0 Vote(s) - 0 Average
  • 1
  • 2
  • 3
  • 4
  • 5
[CA] [CA11] C80 classic not seeing s1000 auto pilot
10-21-19, 12:50 PM (This post was last modified: 10-21-19 01:26 PM by Chuck - Raymarine - Moderator.)
Post: #2
RE: [CA11]C80 classic not seeing s1000 auto pilot
Welcome to the Raymarine Forum Al1947,

The C-Series Classic MFD Reference Guide may be found here. The Autopilot Controls Transducer Status icon will be superimposed with a red "X" if any one of the following conditions occur:
- the operator has not configured the Autopilot Controls feature (MENU->SYSTEM SETUP->SYSTEM INTEGRATION->AUTOPILOT CONTROLS) to ENABLED
- the MFD has not been interfaced via SeaTalk communications protocol to a compatible Raymarine autopilot
- the MFD has suffered a failure of its SeaTalk communications circuitry.
- the autopilot has suffered a failure of its SeaTalk communications circuitry.
- a device within the SeaTalk bus has suffered a failure of its SeaTalk communications circuitry, causing communication between the MFD and autopilot to not be possible.
- a SeaTalk network hardware (wires, junction blocks, etc.) has occurred.
Visit this user's website Find all posts by this user
Quote this message in a reply
Post Reply 


Messages In This Thread
RE: [CA11]C80 classic not seeing s1000 auto pilot - Chuck - Raymarine - Moderator - 10-21-19 12:50 PM

Forum Jump:


User(s) browsing this thread: 1 Guest(s)