[CA] [CA11] All routes showing up on charts
|
10-21-19, 01:37 PM
Post: #2
|
|||
|
|||
RE: [CA11] All routes showing up on charts
Welcome back to the Raymarine Forum Nate,
By default, all routes and waypoints which are imported from a GPX file into the MFD's memory will be shown by default. After importing routes and/or waypoints, one may hide all routes within the Chart application page/pane being viewed by using the command sequence MENU->WAYPOINTS, ROUTES, TRACKS->SHOW/HIDE->HIDE ALL. Waypoints may be similarly hidden. These routes or waypoints may later be shown in a manner similar to that used to hide the routes and waypoints. After doing so and when then seeking to navigate a route, the Chart application will be commanded to follow a route from the route list stored within the MFD's memory. This action will also cause the corresponding route and its waypoints to be be displayed. A feature request will be logged to consider defaulting the Show/Hide attribute for each route or waypoint to be set to HIDE when a route or waypoint is imported. Please click here more information concerning Feature suggestions. |
|||
« Next Oldest | Next Newest »
|
Messages In This Thread |
[CA11] All routes showing up on charts - nharrison5 - 10-18-19, 02:17 PM
RE: [CA11] All routes showing up on charts - Chuck - Raymarine - Moderator - 10-21-19 01:37 PM
RE: [CA11] All routes showing up on charts - nharrison5 - 10-22-19, 12:06 AM
RE: [CA11] All routes showing up on charts - Chuck - Raymarine - Moderator - 10-22-19, 08:31 AM
|
User(s) browsing this thread: 1 Guest(s)