[TG] [TG11] MFD Lockup-alarm active

[BernieK]

Thanks for the reply Tom
The version is the latest 3.11.42.
It was originally showing the fault on the previous version (and I think the one before that).

I have tried to replicate on the trailer, but am unable to reproduce it. Perhaps its some race condition between the route complete and Waypoint arrival.

I have the ACU on an isolation switch so am able to switch the ACU off separately. This generates an alarm which I can acknowledge and cancel. If I do not acknowledge it but instead turn off the P70s, I get a loss of autopilot alarm which I can acknowledge and clear.

The interesting thing is I still have the ACU loss of power alarm active (it appears on the alarm page under active alarms and appears on the home icon) but I am unable to clear it.

However, it does not cause the controls to lock up. If I cycle the MFD power, the alarm is cleared but there is no listing for it in the alarm log.

It is probably completely unrelated, though it may have to do with the level of the alarm (dangerous, warning or information)