Raymarine forum / Raymarine Forums / Multifunction Displays v / Configure Alarm Volume

Post Reply 
 
Thread Rating:
  • 0 Vote(s) - 0 Average
  • 1
  • 2
  • 3
  • 4
  • 5
Configure Alarm Volume
11-06-17, 10:11 AM
Post: #1
[email protected] Offline
Junior Member
**
 		Posts: 8
Joined: Nov 2016
Reputation: 0
Configure Alarm Volume
Is there a way to adjust the alarm volume on a-series MFD in Lighthouse v17 ? I found a thread stating "Raymarine MFDs do not feature a configuration setting whereby there owners may configure the frequency and/or volume of alarms sounded by the MFD" ... looking for confirmation.
Find all posts by this user
Quote this message in a reply
11-06-17, 11:07 AM
Post: #2
Chuck - Raymarine - Moderator Offline
Administrator
*******
 		Posts: 14,319
Joined: Oct 2014
Reputation: 43
RE: Configure Alarm Volume
Welcome to the Raymarine Forum mlpayne,

As indicated within the thread which you have referenced, Raymarine MFDs and LightHouse software produced to date do not feature a configuration setting whereby there owners may configure the frequency and/or volume of alarms sounded by the MFD. The only control presently supported is user control over events will trigger alarms (HOME->SET-UP->ALARMS).
Find all posts by this user
Quote this message in a reply
Post Reply 


Forum Jump:


User(s) browsing this thread: 2 Guest(s)

Contact Us | Raymarine forum | Return to Top | Return to Content | Lite (Archive) Mode | RSS Syndication