Raymarine forum / Raymarine Forums / Fishfinders v / Loss of DSM300 signal

Post Reply 
 
Thread Rating:
  • 0 Vote(s) - 0 Average
  • 1
  • 2
  • 3
  • 4
  • 5
Loss of DSM300 signal
04-19-16, 11:22 AM
Post: #1
Tolly Sasha Offline
Junior Member
**
 		Posts: 1
Joined: Apr 2016
Reputation: 0
Loss of DSM300 signal
I am losing my DSM 300 signaling on a random basis.
It has never work well from install.
I have an E120 Classic with DSM 300 with aB744V transducer.
The DSM is wired to the E120 through a cat 5 wire.
I have upgraded my software to V 4.20
I am looking for advise to help solve this on going issue.
Thanks
Find all posts by this user
Quote this message in a reply
04-19-16, 12:04 PM
Post: #2
Chuck - Raymarine - Moderator Offline
Administrator
*******
 		Posts: 14,319
Joined: Oct 2014
Reputation: 43
RE: Loss of DSM300 signal
Welcome to the Raymarine Forum Tolly Sasha,

Please note that the E-Series Classic MFDs other compatible Ethernet based products are not designed to be interfaced to one another using CAT5 cable. Only an assembly constructed from a pair of SeaTalkhs Cables which have been joined with a SeaTalkhs Crossover Coupler or SeaTalkhs Network Switch should be used to interface the MFD's SeaTalkhs port to the SeaTalkhs port of the DSM. Please click here to view additional information addressing troubleshooting communications between a DSM and an E-Series Classic MFD.
Find all posts by this user
Quote this message in a reply
Post Reply 


Forum Jump:


User(s) browsing this thread: 1 Guest(s)

Contact Us | Raymarine forum | Return to Top | Return to Content | Lite (Archive) Mode | RSS Syndication