Raymarine forum / Raymarine Forums / General Discussions v / Upgrading from Seatalk1 to Seatalk NG

Post Reply 
 
Thread Rating:
  • 0 Vote(s) - 0 Average
  • 1
  • 2
  • 3
  • 4
  • 5
Upgrading from Seatalk1 to Seatalk NG
05-09-16, 04:42 PM
Post: #1
sailaway3662 Offline
Junior Member
**
 		Posts: 2
Joined: Mar 2016
Reputation: 0
Upgrading from Seatalk1 to Seatalk NG
I am replacing my chart plotters and radars and keeping my ST60 instruments that run on Seatalk1. I bought the converter (ST1 to STNG) and hooked everything up.

The Seatalk NG backbone kit comes with a cable to hook to 12v for power. I already have 12v powering my Seatalk1 - will that also power the Seatalk NG backbone or should I connect the NG power cable as well?

Thanks,

Ken
Find all posts by this user
Quote this message in a reply
05-10-16, 10:59 AM
Post: #2
Chuck - Raymarine - Moderator Offline
Administrator
*******
 		Posts: 14,319
Joined: Oct 2014
Reputation: 43
RE: Upgrading from Seatalk1 to Seatalk NG
Welcome to the Raymarine Technical Forum Ken,

The SeaTalk bus must be disconnected from its present source of power as it should instead be powered by the SeaTalkng backbone via the SeaTalk to SeaTalkng Converter. Please click here to view a FAQ addressing this subject.
Find all posts by this user
Quote this message in a reply
Post Reply 


Forum Jump:


User(s) browsing this thread: 1 Guest(s)

Contact Us | Raymarine forum | Return to Top | Return to Content | Lite (Archive) Mode | RSS Syndication