[DG] [DG11] Tillerpilot ST2000 and S100

[bgudm]

Hi,
I bought a boat last year with a standalone ST2000 - which works fine. But now I also bought a s100 remote control with the base station. I'm not sure how to wire this up to get it to work. I don't have any Seatalk and the original connecting plug is no more on the ST2000. The cable has been extended, only using the two 12V power lines.

Any advice will be appreciated ?

Bjarni

[Derek - Raymarine - Moderator]

HI Bjarni

Thankyou for your enquiry.

The S100 base station connects into the SeaTalk network using the red/yellow/screen cable, remember to set the S100 to SAIL, it will be supplied defaulted to FISH patterns and so will not work correctly with your ST2000.

Refer to page 44 of the attached handbook linked here



Thanks
Derek

[bgudm]

Thanks a lot, Derek

[Louise - Raymarine - Moderator]

You are welcome.