[LW] [LW11] Seatalk1 to Seatalkng and Axiom 7, I70s MFD

[Rob Vink]

Previous setup:
ST60+ and ST50 instruments connected with SPX5 Course computer.
i70s MFD connected to SPX 5 with A06047 Seatalk1 to Seatalkng converter cable.
This works fine.

New situation:
Same equipment but Axiom 7 added.
Seatalkng backbone with E22158 converter kit.
Axiom 7 and i70s MFD connected via backbone.

I used the A06047 cable to connect to the SPX5 (red lead not connected).

Axiom 7 works and also displays Seatalk1 data.
Power spur cable connected to battery. Led indicator E22158 shows both seatalkng and seatalk1 are healthy.

i70s does not power up.

Q: Could the A06047 cable be the problem and should I use the converter cable supplied with the E22158 kit and connect this cable to the SPX5? Or is something else causing the problem with the i70s?

[Louise - Raymarine - Moderator]

Dear Rob Vink,

Can you provide a system diagram, only needs to be a sketch.

Did you cut the A06047? Where does the STng plug in to?

Many Thanks
Louise

[Rob Vink]

Dear Louise,
I found out that the i70s is dead. I took it to my dealer and they connected it to a Seatalkng network.

I did cut the A06047 and connected it the SPX5 (not the red lead).
I do see Seatalk1 data on my Axiom 7 so that's ok I think.

The i70s is sent for repair.

Best regards,
Rob

[Louise - Raymarine - Moderator]

Thank you for the update.