Raymarine forum / Raymarine Forums / Autopilots v / [CA] [CA11] Autopilot Bezel and mounting - Mark

Post Reply 
 
Thread Rating:
  • 0 Vote(s) - 0 Average
  • 1
  • 2
  • 3
  • 4
  • 5
[CA] [CA11] Autopilot Bezel and mounting - Mark
06-25-19, 09:43 AM (This post was last modified: 06-25-19 03:57 PM by Chuck - Raymarine - Moderator.)
Post: #1
sail545 Offline
Junior Member
**
 		Posts: 1
Joined: Jun 2019
Reputation: 0
[CA11] Autopilot Bezel and mounting - Mark
Attached are pics received of the bezel on my new autopilot control unit. It is too small. Also i did not receive any mounting screws that would screw into back of the pilot to through mount. Can you please look into this and correct? Posting this as requested by Mark in tech support, as they cannot receive email.
Thanks!


Attached File(s) Thumbnail(s)
       
Find all posts by this user
Quote this message in a reply
06-25-19, 03:59 PM (This post was last modified: 06-25-19 04:00 PM by Chuck - Raymarine - Moderator.)
Post: #2
Chuck - Raymarine - Moderator Offline
Administrator
*******
 		Posts: 14,319
Joined: Oct 2014
Reputation: 43
RE: [CA11] Autopilot Bezel and mounting - Mark
Welcome to the Raymarine Forum sail545,

Your photo shows that the black bezel is already installed on the autopilot's control head. This black bezel must be removed to permit the gun metal painted bezel to be installed.
Find all posts by this user
Quote this message in a reply
Post Reply 


Forum Jump:


User(s) browsing this thread: 1 Guest(s)

Contact Us | Raymarine forum | Return to Top | Return to Content | Lite (Archive) Mode | RSS Syndication