Raymarine forum / Raymarine Forums / Multifunction Displays v / [CA] [CA11] Autoroute

Post Reply 
 
Thread Rating:
  • 0 Vote(s) - 0 Average
  • 1
  • 2
  • 3
  • 4
  • 5
[CA] [CA11] Autoroute
07-17-19, 10:01 AM (This post was last modified: 07-22-19 02:54 PM by Chuck - Raymarine - Moderator.)
Post: #1
[email protected] Offline
Junior Member
**
 		Posts: 3
Joined: Feb 2019
Reputation: 0
[CA11] Autoroute
I recently installed a Axiom MFD currently running ver3.5.40 software. When doing a long touch on the screen the pop up menu does not provide an option to autoroute to the spot on the screen. Is there a setting that I need to adjust to use the autoroute feature?

Thanks
Marc
Find all posts by this user
Quote this message in a reply
07-22-19, 03:01 PM (This post was last modified: 07-22-19 03:04 PM by Chuck - Raymarine - Moderator.)
Post: #2
Chuck - Raymarine - Moderator Offline
Administrator
*******
 		Posts: 14,319
Joined: Oct 2014
Reputation: 43
RE: [CA11] Autoroute
Welcome to the Raymarine Forum Marc,

Please note that the software update within your MFDs(s) was released than 1-1/2 years ago and is now five software releases behind the currently supported software level. It is correspondingly recommended that the software within your MFDs be updated to LightHouse 3 v3.10.39 or later. It is additionally recommended that you verify that your Navionics chart card a Freshest Data subscription which is less than 1 year old, as the autorouting feature requires an active subscription. Finally, in addition to an active Navionics Freshest Data subscription, it is recommended that the Navionics charts be updated with Freshest Data to ensure the most accurate autorouting.
Find all posts by this user
Quote this message in a reply
Post Reply 


Forum Jump:


User(s) browsing this thread: 3 Guest(s)

Contact Us | Raymarine forum | Return to Top | Return to Content | Lite (Archive) Mode | RSS Syndication