Raymarine forum / Raymarine Forums / Networking / System Integration v / [CA] [CA11] Adding B&G to EVO-1 via Seatalkng

Post Reply 
 
Thread Rating:
  • 0 Vote(s) - 0 Average
  • 1
  • 2
  • 3
  • 4
  • 5
[CA] [CA11] Adding B&G to EVO-1 via Seatalkng
09-12-19, 11:38 AM (This post was last modified: 09-12-19 12:21 PM by Chuck - Raymarine - Moderator.)
Post: #1
jvolpehoo Offline
Junior Member
**
 		Posts: 1
Joined: Jun 2019
Reputation: 0
[CA11] Adding B&G to EVO-1 via Seatalkng
See attached diagram:

Is there any problem daisychaining either the MFD or Radar via the extra port on the P70 control head? I have all the adapter cables. The P70 cannot see the mfd but the MFD can see the EVO-! components but won't allow autopilot setup.


Attached File(s) Thumbnail(s)
   
Find all posts by this user
Quote this message in a reply
09-12-19, 12:27 PM
Post: #2
Chuck - Raymarine - Moderator Offline
Administrator
*******
 		Posts: 14,319
Joined: Oct 2014
Reputation: 43
RE: [CA11] Adding B&G to EVO-1 via Seatalkng
Welcome to the Raymarine Forum jvolpehoo,

Should the equipment have involved a Raymarine MFD and should the total length of the spur cables used to daisy chain the MFD to the p70 and the backbone spur socket to the p70 not exceed 6m, then it would be possible to daisy chain the MFD to the p70. However, no such guarantee could be made with a third party MFD. The safest bet would be follow the NMEA 2000 standard (also Raymarine best installation practice) of interfacing each device as an individual spur to the backbone rather than utilizing daisy chains.
Find all posts by this user
Quote this message in a reply
Post Reply 


Forum Jump:


User(s) browsing this thread: 2 Guest(s)

Contact Us | Raymarine forum | Return to Top | Return to Content | Lite (Archive) Mode | RSS Syndication