[CA] [CA11] I50 and I60 compatible with my present hardware?

[udo]

Thanks, I wanted to be clear, now it is clear to me.


I am afraid, one more question.

Because now I am able to consider the I70 package with sensors for wind, speed and ITC-5 I tried to find out exactly which through hull sensor is supplied with this package.

Many dealers now have the same package on offer here in Sweden.
To give you an idea of which package I mean, you can see one here: https://www.benns.se/elektroniknavigatio...nd-log-lod

No dealer is replying to my email with this question, so I am afraid I have to turn to Raymarine (you in this case)

In various advertisements I see: A22154 - DST800 52mm Analog 200KHZ x 1st

But the A22154 is the D800/P17
(http://www.raymarine.com/view/?id=1479&c...8&col=1483)

and NOT the DST800
(http://www.raymarine.com/view/?id=1479&c...8&col=1483)


So which sensor is supplied with this package?

Thanks for letting me know

[Chuck - Raymarine - Moderator]

Udo,

Q. A22154 is the D800/P17
A. This is an incorrect statement. A22154 is the part number for the DST800 Triducer. The part number for the D800/P17 is E26030. The A22154 DST800 Triducer is packaged with the i70 Instrument Pack which included an iTC-5.

[udo]

You write here: ''at this time, it is recommended that an ITC-5 and that the transducers specified above be installed if an i70S MFID will be installed.

Do you mean: the Smart DST800 and Smart DT800

or:

M78713-PZ P319 Low Profile Through Hull Plastic Depth Transducer 14m Cable
- E26031 ST800/P120 Speed/Temperature Low Profile Retractable Through Hull Transducer - 13.7m Cable

[Chuck - Raymarine - Moderator]

udo,

I was recommending the iTC-5 and the following transducers:
- M78713-PZ P319 Low Profile Through Hull Plastic Depth Transducer 14m Cable
- E26031 ST800/P120 Speed/Temperature Low Profile Retractable Through Hull Transducer - 13.7m Cable

Please refer to my earlier post within this thread stating that we have received recent reports of reduced levels of depth performance from those using the Smart DST800 and Smart DT800, at this time, it would be recommended at this time that an iTC-5 and that the transducers specified above be installed if an i70S MFID will be installed.