Raymarine forum / Raymarine Forums / Multifunction Displays v / [CA] [CA11] Axiom to cpt 100 dvs transducer. Adapter needed?

Post Reply 
 
Thread Rating:
  • 0 Vote(s) - 0 Average
  • 1
  • 2
  • 3
  • 4
  • 5
[CA] [CA11] Axiom to cpt 100 dvs transducer. Adapter needed?
04-27-20, 07:04 AM (This post was last modified: 04-27-20 01:24 PM by Chuck - Raymarine - Moderator.)
Post: #1
jwex16 Offline
Junior Member
**
 		Posts: 1
Joined: Jan 2020
Reputation: 0
[CA11] Axiom to cpt 100 dvs transducer. Adapter needed?
Just installed axiom 9 and the recommended cpt100 dvs transducer. The connections are both male. Now I see there is an adapter you can buy. Is there a workaround. If I need to get the adapter I would have spent the little bit extra to get the RV 100. Where does the Ferrell go. Close to the end of the transducer cable or on the adapter cable closest to the display?
Find all posts by this user
Quote this message in a reply
04-27-20, 01:26 PM (This post was last modified: 04-27-20 01:53 PM by Chuck - Raymarine - Moderator.)
Post: #2
Chuck - Raymarine - Moderator Offline
Administrator
*******
 		Posts: 14,319
Joined: Oct 2014
Reputation: 43
RE: [CA11] Axiom to cpt 100 dvs transducer. Adapter needed?
Welcome to the Raymarine Forum jwex16,

Of the three types of Axiom MFD (Axiom, Axiom DV, and Axiom RV), which model of Axiom MFD are you seeking to interface the CPT100DVS transducer to?
Find all posts by this user
Quote this message in a reply
Post Reply 


Forum Jump:


User(s) browsing this thread: 1 Guest(s)

Contact Us | Raymarine forum | Return to Top | Return to Content | Lite (Archive) Mode | RSS Syndication