Post Reply 
 
Thread Rating:
  • 0 Vote(s) - 0 Average
  • 1
  • 2
  • 3
  • 4
  • 5
[CA] [CA11] Rs125 cabling
12-23-19, 01:05 AM (This post was last modified: 12-23-19 11:05 AM by Chuck - Raymarine - Moderator.)
Post: #1
[CA11] Rs125 cabling
In what way can I use/convert my rs125 gps cable (mounts on buggy top of tower) to a RS150? Can I use an rs150 on an E120 classic and if so how would it interface. Thanks
Find all posts by this user
Quote this message in a reply
12-23-19, 11:09 AM (This post was last modified: 12-23-19 11:11 AM by Chuck - Raymarine - Moderator.)
Post: #2
RE: [CA11] Rs125 cabling
Welcome back to the Raymarine Forum Never II Nauti,

Q. In what way can I use/convert my rs125 gps cable to a RS150?
A. Unfortunately, the Raystar 125 GPS Sensor's Cable cannot be adapted/used to instead interface a NMEA 2000 device to the system. The SeaTalkng Spur Cable supplied with the Raystar 150 GPS Sensor (or a shorter Spur Cable) must be used to interface the Raystar 150 GPS Sensor to a spur socket within system's powered and properly terminated SeaTalkng / NMEA 2000 backbone to which your system's Axiom Pro MFD will also be interfaced as a spur.
Find all posts by this user
Quote this message in a reply
05-29-20, 05:40 PM
Post: #3
RE: [CA11] Rs125 cabling
Chuck

Can you tell me how the RS125 would be wired into an E120? I am unable to figure out the wiring set currently. I believe it must be thru the NMEA 0183 plug or the SeaTalk/alarm plug as the seatalk 2 and seatalk hs were not used for it. Thanks
Find all posts by this user
Quote this message in a reply
06-11-20, 12:19 PM
Post: #4
RE: [CA11] Rs125 cabling
Please see the attached drawing,


Attached File(s) Thumbnail(s)
   
Find all posts by this user
Quote this message in a reply
Post Reply 


Forum Jump:


User(s) browsing this thread: 2 Guest(s)