Post Reply 
 
Thread Rating:
  • 0 Vote(s) - 0 Average
  • 1
  • 2
  • 3
  • 4
  • 5
[CA] [CA11] RV-100 Transducer Placement
12-10-19, 03:36 PM (This post was last modified: 12-10-19 03:41 PM by Chuck - Raymarine - Moderator.)
Post: #5
RE: [CA11] RV-100 Transducer Placement
I am trying to make the best of a sub-optimal situation here and appreciate your help.

First let me say that I troll at 8 knots with 4 lines in the water 80% of the time and when I am not trolling I am not looking for fish.

That being said I went to the boat and measured and there is simply not enough room to install a pair of RV-3XX thru the hull sensors so I need to find a way to make the RV-100 work.

Option A - I can install the RV100 on the step close to the Garboard drain (see attached diagram) on the left side at a location where there is nothing but smooth hull in front of it. I have attached a drawing. The wire would have to travel about 10" horizontally (either on an angle or attached to the hull) before running up the transom.

Option B - I can install the transducer in the exact center of the hull above the step.

Can you opine on which option is the better choice and why?


Attached File(s) Thumbnail(s)
   

.pdf  RV-100.pdf (Size: 414.75 KB / Downloads: 347)
Find all posts by this user
Quote this message in a reply
Post Reply 


Messages In This Thread
RE: [CA11] RV-100 Transducer Placement - DFMott - 12-10-19 03:36 PM

Forum Jump:


User(s) browsing this thread: 1 Guest(s)