Post Reply 
 
Thread Rating:
  • 0 Vote(s) - 0 Average
  • 1
  • 2
  • 3
  • 4
  • 5
[CA] [CA11] i70s - Lighthouse Documentation?
01-14-20, 03:28 PM (This post was last modified: 01-14-20 03:30 PM by Chuck - Raymarine - Moderator.)
Post: #2
RE: [CA11] i70s - Lighthouse Documentation?
Keith,

When operating with the latest available software, the i70S and i70 MFID will each display identical graphics and support the same options. Unfortunately, the documentation for the i70S and i70 MFIDs does not show every graphic and data combination possible ... the combinations and permutations would simply make including such infeasible. Are you simply seeking for the i70S/i70 MFID to repeat heading from your autopilot? If so and should the i70S/i70 MFID be interfaced to the backbone to which the autopilot has also been interfaced, then the heading data value may be expressed within multigauge graphic, as numerical value, or as a graphic displaying heading alone. An image of the multigauge graphic which I have referenced is shown below.

[Image: i70s_Hero_Front.jpg]
Find all posts by this user
Quote this message in a reply
Post Reply 


Messages In This Thread
RE: [CA11] i70s - Lighthouse Documentation? - Chuck - Raymarine - Moderator - 01-14-20 03:28 PM

Forum Jump:


User(s) browsing this thread: 3 Guest(s)