[CA11] Interfacing Axiom 9 to St40-bidata and tillerpilot

Thread Rating:

0 Vote(s) - 0 Average
1
2
3
4
5

Threaded Mode | Linear Mode

[CA] [CA11] Interfacing Axiom 9 to St40-bidata and tillerpilot

01-27-20, 04:25 PM (This post was last modified: 01-27-20 04:34 PM by Chuck - Raymarine - Moderator.)

Post: #5

CaptnFrank Offline

Junior Member

Posts: 10
Joined: Mar 2019
Reputation: 0

RE: [CA11] Interfacing Axiom 9 to St40-bidata and tillerpilot

Chuck,

I think I understand the use of the D244 junction box to connect both the ST40 and the ST1000 to the seatalk converter. I'm wondering if it wouldn't be possible to splice a two pair awg wire of appropriate size into to the seatalk converter cable and run it to the ST1000+? This would save about $150.00.

Also, I'm not quite sure what you mean by "circuit supplying power to the SeaTalkng / NMEA 2000 backbone's power cable should be switched.". Switched from where to where.

Thanks,
Frank

« Next Oldest | Next Newest »

Messages In This Thread

[CA11] Interfacing Axiom 9 to St40-bidata and tillerpilot - CaptnFrank - 01-20-20, 11:41 AM

RE: [CA11] Interfacing Axiom 9 to St40-bidata and tillerpilot - Chuck - Raymarine - Moderator - 01-22-20, 10:35 AM

RE: [CA11] Interfacing Axiom 9 to St40-bidata and tillerpilot - CaptnFrank - 01-27-20, 12:24 PM

RE: [CA11] Interfacing Axiom 9 to St40-bidata and tillerpilot - Chuck - Raymarine - Moderator - 01-27-20, 01:02 PM

RE: [CA11] Interfacing Axiom 9 to St40-bidata and tillerpilot - CaptnFrank - 01-27-20 04:25 PM

RE: [CA11] Interfacing Axiom 9 to St40-bidata and tillerpilot - Chuck - Raymarine - Moderator - 01-27-20, 04:43 PM

User(s) browsing this thread: 1 Guest(s)