Post Reply 
 
Thread Rating:
  • 0 Vote(s) - 0 Average
  • 1
  • 2
  • 3
  • 4
  • 5
[TG] [TG11] RV100
03-07-20, 04:04 AM
Post: #6
RE: [TG11] RV100
(02-19-20 11:24 PM)Tom - Raymarine - Moderator Wrote:  Thanks Ryan. I'll look forward to seeing images in our 65/15/0 setup if the problem recurs. It does indeed look like an interference signal, but I don't recall seeing one quite like that before so I will be interested to follow this through to a conclusion. It would also be good to see some of the SV problems if you can capture those too.

Regards,
Tom

Hi Tom,

I finally got to get out in the boat and set the MFD settings to the 65, 15 and 0, I think I had to change the ping to full and colour to 100 as well.

Any way I have taken a heap of screen shots in Low, Medium and High Chirp, DV, Side vision. One thing I did notice when the setting were switched to manual I tried turning the engine off and there didn't seem to make any difference to the out come to the images so I kept trying at different speeds. Another thing I didn't do straight away was have depth on the page info. But the depth readings are always pretty accurate compared to the navionic charts.

I"ll be very interested to see what your thoughts are on the images. also I will attach some photo's of the 2 transducer locations tomorrow bit dark out side at the moment.

Kind Regards
Ryan


Attached File(s) Thumbnail(s)
                                           
Find all posts by this user
Quote this message in a reply
Post Reply 


Messages In This Thread
[TG11] RV100 - Ryan C2400 - 02-04-20, 06:23 PM
RE: [TG11] RV100 - Ryan C2400 - 02-16-20, 09:39 PM
RE: [TG11] RV100 - Ryan C2400 - 02-19-20, 11:50 PM
RE: [TG11] RV100 - Ryan C2400 - 03-07-20 04:04 AM
RE: [TG11] RV100 - Ryan C2400 - 03-07-20, 06:36 PM
RE: [TG11] RV100 - Ryan C2400 - 03-09-20, 04:05 PM
RE: [TG11] RV100 - Ryan C2400 - 03-09-20, 06:09 PM
RE: [TG11] RV100 - Ryan C2400 - 03-16-20, 12:18 AM

Forum Jump:


User(s) browsing this thread: 1 Guest(s)