Post Reply 
 
Thread Rating:
  • 0 Vote(s) - 0 Average
  • 1
  • 2
  • 3
  • 4
  • 5
[LW] [LW11] acu200 +EV1 and st6002 compatibility???
02-07-20, 09:32 AM
Post: #2
RE: [LW11] acu200 +EV1 and st6002 compatibility???
Dear getaway.

Thank you for your post.

You can use the ST6002 installation manual to perform the calibration. The docuemnt is 'Smart Pilot install & commissioning with ST6001, ST6002, ST7001, ST7002, ST8001, ST8002 controllers' - this can be found under legacy pilot manuals>pilot control here.

The limitations are as follows;
-Compass reset, Diagnostics & Patterns not available!
-Hard over time for RRT-less operation not available!
-Dockside commissioning not available!
-Drive and Rudder Offset have to be set manually!
Some functions are different:
-Response – (1-2-3)
-Vessel type – (Semi-Disp.-Planing-Workboat-Sail)
-Drive Type (3-4)

How have you connected the ST1 to STng convertor? Is the backbone correctly terminated?

Are you getting wind data on any of the other products?

Many Thanks
Louise
Find all posts by this user
Quote this message in a reply
Post Reply 


Messages In This Thread
RE: [LW11] acu200 +EV1 and st6002 compatibility??? - Louise - Raymarine - Moderator - 02-07-20 09:32 AM

Forum Jump:


User(s) browsing this thread: 1 Guest(s)