Post Reply 
Thread Rating:
  • 0 Vote(s) - 0 Average
  • 1
  • 2
  • 3
  • 4
  • 5
[DG] [DG11] Test of new ST60 Wind PCB
02-14-20, 11:04 AM
Post: #2
RE: [DG11] Test of new ST60 Wind PCB
Hi Juergen

Thank you for your enquiry

You should see a higher voltage on the output from the Speed from the masthead unit, you should expect to see between 3 to 5v or 0 volts when slowly turning the masthead anemometer, the output is a square wave twice a rotation.

The 2.5v measurement is too low - however if the wind display to which you are connecting it is particularly sensitive, you might find that it triggers the speed sufficiently to give a ready, might be an idea to connect it to a display and test directly.

Find all posts by this user
Quote this message in a reply
Post Reply 

Messages In This Thread
RE: [DG11] Test of new ST60 Wind PCB - Derek - Raymarine - Moderator - 02-14-20 11:04 AM

Forum Jump:

User(s) browsing this thread: 1 Guest(s)