Post Reply 
 
Thread Rating:
  • 0 Vote(s) - 0 Average
  • 1
  • 2
  • 3
  • 4
  • 5
ST60 Wind Linearising and aligning transducer at the dock
05-20-20, 07:15 PM
Post: #1
ST60 Wind Linearising and aligning transducer at the dock
I have replaced my older transducer and need to do the "Linearising and aligning" procedures. I currently can't sail out of my marina due to shutdown and was wondering:
- instead of doing two circles with my boat I went up the mast and turned the wind indicator slowly two times. It seems like ST60 took it, however, I just wanted to make sure it was OK?
- also, the manual says to align the wind direction to enter the calibration mode and "sail into the wind and adjust the analog wind indicator angle to zero". My question can I just do it at the dock without taking the boat out and adjust the wind angle to what it is by entering offset to indicate the current wind direction at the dock?

Thank you in advance for your help!
Find all posts by this user
Quote this message in a reply
05-21-20, 10:54 AM
Post: #2
RE: ST60 Wind Linearising and aligning transducer at the dock
Hello beckett,

You can linearize the wind vane as described in your post. I would however wait to perform the second part of sailing into the wind so that it is accurate.

Chris,
Find all posts by this user
Quote this message in a reply
Post Reply 


Forum Jump:


User(s) browsing this thread: 1 Guest(s)