[TG] [TG11] Loss of GPS satellite fix

[Tom - Raymarine - Moderator]

Hello Bill,

Thanks. A few questions:

1. The dates of the Lost Fix alarms shown in the history are 24th May - have you used the system since, and did you see fix problems then? Was anything different between then and when you took the photos? The fix quality shown in the photos is excellent.
2. When you get the Route Complete message, I assume that the next waypoint is still some distance off? How far, approximately? What is your Waypoint Arrival Radius in your Alarm setup? Do you have a Seatalk1 - SeatalkNG convertor in the system? (I am looking possible early waypoint-arrival alerts in a couple of systems where there's an ST1-STNG convertor.)
3. The Axiom Pro and eS show different GPS fix source information in the satellite status page title-bar, although they show the same fix data. It's possible there's some confusion in the system configuration about what GPS source is in use, and this might cause your false Route Complete alert. Could you check what's shown in Home > Settings > Network > Data Sources on the Master display? It would be a good idea in this system to manually select the RS130 as the source - if this is already selected, please toggle to Auto and then back to Manual/RS130 in order to be sure that both displays' setup holds the same state. You can get this sort of problem after an MFD change (though the reset should have resolved it), or if a source selection is done whilst one display is de-powered.
   
   

Thanks,
Tom