European Union (.eu)
United States (.com)
United Kingdom (.co.uk)
Australia (.com.au)
Denmark (.dk)
Finland (.fi)
France (.fr)
Germany (.de)
Italy (.it)
Norway (.no)
Netherlands (.nl)
Spain (.es)
Sweden (.se)
Search
Member List
Calendar
Help
|
[TG] [TG11] Replacing st-50 wind with st-60
|
|
06-16-20, 09:21 PM
Post: #4
|
|||
|
|||
|
RE: [TG11] Replacing st-50 wind with st-60
Hello Arcflash,
Yes, a Micro-C connector could do that job. Obviously check the connector's IP rating if it's going to be in an exposed location, and any connection should have a drip loop to make sure that water isn't running down the cable and onto the connector. The wind signal cables are analogue and cannot be connected directly into NMEA2000. The output from our ITC5 instrument transducer convertor is NMEA2000 (via Raymarine SeatalkNG connectors), and the analogue wind can connect to that, but you would then need a Lighthouse 3 MFD or i70S instrument in order to calibrate the wind data. Regards, Tom Raymarine since 1999. Interests: Diagnosis of problems in sonar/fishfinders, NMEA2000, ethernet comms, autopilots, thermal cameras Location: Sydney, Australia. Please don't PM me asking for direct support, please ask a public question instead so that others can see the question and answer. Forum posts will always be answered before PM requests. |
|||
|
|
« Next Oldest | Next Newest »
|
| Messages In This Thread |
|
[TG11] Replacing st-50 wind with st-60 - ritsim - 06-02-20, 08:23 AM
RE: [TG11] Replacing st-50 wind with st-60 - Tom - Raymarine - Moderator - 06-11-20, 01:25 AM
RE: [TG11] Replacing st-50 wind with st-60 - Arcflash - 06-15-20, 08:02 AM
RE: [TG11] Replacing st-50 wind with st-60 - Tom - Raymarine - Moderator - 06-16-20 09:21 PM
|
User(s) browsing this thread: 1 Guest(s)