The following warnings occurred:
Warning [2] count(): Parameter must be an array or an object that implements Countable - Line: 802 - File: showthread.php PHP 7.4.33 (Linux)
File Line Function
/showthread.php 802 errorHandler->error




Raymarine forum / Raymarine Forums / Instruments v / i70 transducer calibration through iTC-5

Post Reply 
 
Thread Rating:
  • 0 Vote(s) - 0 Average
  • 1
  • 2
  • 3
  • 4
  • 5
i70 transducer calibration through iTC-5
06-20-16, 07:51 PM
Post: #1
Dave Offline
Junior Member
**
 		Posts: 8
Joined: Feb 2016
Reputation: 0
i70 transducer calibration through iTC-5
The i70 displays all of my transducer data, but I cannot calibrate any of them. When I get to the iTC-5 menu on the i70, all of the transducer options (Depth, Speed, Wind, etc) are grayed out and can't be selected.

The i70 and iTC-5 were just installed, replacing an i50 tridata. After installation, I ran a software update using my a95 MFD wifi connection. It did not identify any updates for the i70 or iTC-5 (only the p70 and Evolution ACU).

The i70 is daisy-chained to a p70, which is connected to a 5-way SeaTalkng connector. I wouldn't think the order matters, does it?

Any ideas about what might be preventing the transducer calibration?

(Diagnostic data attached)


Attached File(s)
.html  Diagnostic_Data_0002_All_Devices_20-34-16_06-20-2016.html (Size: 20.46 KB / Downloads: 1309)
Find all posts by this user
Quote this message in a reply
Post Reply 


Messages In This Thread
i70 transducer calibration through iTC-5 - Dave - 06-20-16 07:51 PM

Forum Jump:


User(s) browsing this thread: 1 Guest(s)

Contact Us | Raymarine forum | Return to Top | Return to Content | Lite (Archive) Mode | RSS Syndication