e165 v17.45 units selection
|
08-02-16, 02:26 PM
Post: #4
|
|||
|
|||
RE: e165 v17.45 units selection
Hello Markct,
The only device that has had some history with units is the ST1 to SeaTalkNg converter, E22158, but that was rectified with software. You have stated your converter has the latest version of V2.01. At this point we need to verify that your STNG bus is configured correctly, has proper termination and is powered from only one source. Then start eliminating connections. Try removing the ST1 devices from the converter, (converter still needs to be powered and connected to the bus, leaving just the RS130 and the converter) and see if unit selection is possible. If it is, then one device at a time start adding in the ST1 devices, till the issue shows up. If you remove the ST1 devices from the converter and unit selection is still not possible, I'd replace the converter. |
|||
« Next Oldest | Next Newest »
|
Messages In This Thread |
e165 v17.45 units selection - markct - 08-01-16, 01:02 PM
RE: e165 v17.45 units selection - Mark - Raymarine - Moderator - 08-01-16, 02:48 PM
RE: e165 v17.45 units selection - markct - 08-01-16, 03:30 PM
RE: e165 v17.45 units selection - Mark - Raymarine - Moderator - 08-02-16 02:26 PM
RE: e165 v17.45 units selection - markct - 08-02-16, 03:02 PM
RE: e165 v17.45 units selection - markct - 08-09-16, 12:33 PM
RE: e165 v17.45 units selection - Chuck - Raymarine - Moderator - 08-09-16, 01:55 PM
RE: e165 v17.45 units selection - markct - 08-10-16, 12:17 PM
RE: e165 v17.45 units selection - Chuck - Raymarine - Moderator - 08-10-16, 03:01 PM
RE: e165 v17.45 units selection - markct - 08-11-16, 08:36 AM
RE: e165 v17.45 units selection - Chuck - Raymarine - Moderator - 08-11-16, 09:15 AM
|
User(s) browsing this thread: 1 Guest(s)