Post Reply 
 
Thread Rating:
  • 0 Vote(s) - 0 Average
  • 1
  • 2
  • 3
  • 4
  • 5
Auto Pilot Not Functioning After Update to 15.59
02-25-16, 02:39 PM
Post: #7
RE: Auto Pilot Not Functioning After Update to 15.59
(02-24-16 02:43 PM)Steve - Raymarine - Moderator Wrote:  If you press Auto and the drive goes hardover, then the motor polarization is incorrect and you will need to switch the Motor A/B wires terminated to the ACU.

I went to the boat this morning, prepared to switch the motor wires as suggested. But, I thought that since the autopilot worked before, the motor must have been wired correctly. So, I went through the set-up wizards again. This time I noted that the pump selection was wrong (I missed this before) and changed that. Went through the rest of the set-up procedures and took the boat out. Now, the autopilot worked fine. However, I also noted that the system was now displaying true vs. magnetic courses and changed that as well.

Is it possible that when I did the software updates that there was a system reset?

In any event, things are now back to normal.
Find all posts by this user
Quote this message in a reply
Post Reply 


Messages In This Thread
RE: Auto Pilot Not Functioning After Update to 15.59 - Joe - 02-25-16 02:39 PM

Forum Jump:


User(s) browsing this thread: 1 Guest(s)