Raymarine forum / Raymarine Forums / Instruments v / ST70 wont run calibrate vane test

Post Reply 
 
Thread Rating:
  • 0 Vote(s) - 0 Average
  • 1
  • 2
  • 3
  • 4
  • 5
ST70 wont run calibrate vane test
09-24-16, 11:50 AM (This post was last modified: 09-26-16 08:26 AM by Chuck - Raymarine - Moderator.)
Post: #7
Andrew41 Offline
Junior Member
**
 		Posts: 4
Joined: Aug 2016
Reputation: 0
RE: ST70 wont run calibrate vane test
Chuck I have an update. I was able to get another brand new Itc5 and installed it today. I updated the software and then tried to calibrate. Exactly the same issue happened as detailed above. No change at all. Intersting to note is I checked the voltages at the base of the mast coming from the wind vane. Voltage from red to shield with the wire going to the vane disconnected is 7.95V. When I connect the red going to the vane the voltage drops to 5.64V. It sure seems the vane has an issue. What do you think?
Find all posts by this user
Quote this message in a reply
Post Reply 


Messages In This Thread
RE: ST70 wont run calibrate vane test - Andrew41 - 09-24-16 11:50 AM

Forum Jump:


User(s) browsing this thread: 1 Guest(s)

Contact Us | Raymarine forum | Return to Top | Return to Content | Lite (Archive) Mode | RSS Syndication