Autopilot repair

Thread Rating:

0 Vote(s) - 0 Average
1
2
3
4
5

Threaded Mode | Linear Mode

Autopilot repair

11-01-16, 07:36 PM

Post: #1

Bajanfisherman Offline

Junior Member

Posts: 7
Joined: Oct 2016
Reputation: 0

Autopilot repair

Hi,
I recently installed the following components replacing an older SPX30 computer which was faulty.
ACU-200, EV-1 Sensor Core.
I am reusing the ST6002+ Head Controller and hydraulic pump (Type1).
I am getting a "NO Pilot" message on the ST6002.
I have used the SeaTalk to SeaTalkNg converter kit and terminated the backbone.
The ST6002 plugs into the yellow SeaTalk connector, the Ev-1 and ACU plug into the other two white spur connectors.
Power for the backbone comes from the ACU200 via the spur cable.
Am I missing anything here?

Thanks

« Next Oldest | Next Newest »

Messages In This Thread

Autopilot repair - Bajanfisherman - 11-01-16 07:36 PM

RE: Autopilot repair - Chuck - Raymarine - Moderator - 11-04-16, 04:37 AM

RE: Autopilot repair - Bajanfisherman - 11-06-16, 03:16 AM

RE: Autopilot repair - Chuck - Raymarine - Moderator - 11-09-16, 04:14 PM

RE: Autopilot repair - Bajanfisherman - 11-09-16, 04:48 PM

RE: Autopilot repair - Bajanfisherman - 11-14-16, 08:53 AM

RE: Autopilot repair - Chuck - Raymarine - Moderator - 11-15-16, 10:32 AM

RE: Autopilot repair - Bajanfisherman - 11-15-16, 12:00 PM

RE: Autopilot repair - Chuck - Raymarine - Moderator - 11-15-16, 01:24 PM

User(s) browsing this thread: 1 Guest(s)