Raymarine forum / Raymarine Forums / Multifunction Displays v / Upgrading older system...

Post Reply 
 
Thread Rating:
  • 2 Vote(s) - 2 Average
  • 1
  • 2
  • 3
  • 4
  • 5
Upgrading older system...
02-26-17, 08:03 PM
Post: #9
FishBut Offline
Junior Member
**
 		Posts: 6
Joined: Jan 2017
Reputation: 0
RE: Upgrading older system...
Chuck, got everything wired up this weekend. Everything seemed fine (radar and sonar) but could not get a gps signal. Wired the seaTalk 120 as described above and set the MFD for seaTalk 1. Wondering if the 120 is having an issue. I opened it up and checked the 3v battery and I am showing no volts at all. By the way the battery is in there I take it these are not meant to be replaced, correct?

Any other suggestions for troubleshooting this? Dumb question but I only wired the three wires mentioned above for the SeaTalk connection. There is no other wiring or wiring for power needed, correct?
Find all posts by this user
Quote this message in a reply
Post Reply 


Messages In This Thread
Upgrading older system... - FishBut - 01-20-17, 12:39 PM
RE: Upgrading older system... - FishBut - 01-20-17, 02:31 PM
RE: Upgrading older system... - FishBut - 02-08-17, 09:25 AM
RE: Upgrading older system... - FishBut - 02-08-17, 11:53 AM
RE: Upgrading older system... - FishBut - 02-26-17 08:03 PM
RE: Upgrading older system... - FishBut - 02-28-17, 06:57 AM

Forum Jump:


User(s) browsing this thread: 1 Guest(s)

Contact Us | Raymarine forum | Return to Top | Return to Content | Lite (Archive) Mode | RSS Syndication