The following warnings occurred:
Warning [2] count(): Parameter must be an array or an object that implements Countable - Line: 802 - File: showthread.php PHP 7.4.33 (Linux)
File Line Function
/showthread.php 802 errorHandler->error




Raymarine forum / Raymarine Forums / Autopilots v / Type 150/400 Autopilot

Post Reply 
 
Thread Rating:
  • 0 Vote(s) - 0 Average
  • 1
  • 2
  • 3
  • 4
  • 5
Type 150/400 Autopilot
01-24-17, 11:12 AM
Post: #1
oceanharmony Offline
Junior Member
**
 		Posts: 3
Joined: Dec 2016
Reputation: 0
Type 150/400 Autopilot
The autopilot controller is ST6002 connected to a Type 150/400 course computer that powers a 24volt Linear Drive (M81134). When the Autopilot is engaged the Clutch acitivates (the wheel locks in position) but the autopilot does not correct course. After a few minutes an error message "DRIVE STOPPED" appears. The rudder limits are all in order. I checked the voltage at the course computer. Supply voltage is 24 volts but the Drive Motor output voltage is zero. Therefore conclude that no power is being supplied to the Linear Drive. Is this a failure of the actual Course compuer or some other issue?
Appreciate help.
John
Find all posts by this user
Quote this message in a reply
Post Reply 


Messages In This Thread
Type 150/400 Autopilot - oceanharmony - 01-24-17 11:12 AM

Forum Jump:


User(s) browsing this thread: 1 Guest(s)

Contact Us | Raymarine forum | Return to Top | Return to Content | Lite (Archive) Mode | RSS Syndication