Raymarine forum / Raymarine Forums / Autopilots v / ST6000 Disengaging to Standby

Post Reply 
 
Thread Rating:
  • 0 Vote(s) - 0 Average
  • 1
  • 2
  • 3
  • 4
  • 5
ST6000 Disengaging to Standby
04-24-17, 10:23 AM (This post was last modified: 04-24-17 10:24 AM by Chuck - Raymarine - Moderator.)
Post: #6
Chuck - Raymarine - Moderator Offline
Administrator
*******
 		Posts: 14,319
Joined: Oct 2014
Reputation: 43
RE: ST6000 Disengaging to Standby
David,

If you can effect the failure by wiggling wires to the course computer, then there is either a failure within the cable which is being wiggled or the connector on the course computer's circuit board. You may want to convey this information to your installer to further fault isolate the problem.
Find all posts by this user
Quote this message in a reply
Post Reply 


Messages In This Thread
ST6000 Disengaging to Standby - deboyes - 03-22-17, 09:19 AM
RE: ST6000 Disengaging to Standby - Chuck - Raymarine - Moderator - 04-24-17 10:23 AM

Forum Jump:


User(s) browsing this thread: 1 Guest(s)

Contact Us | Raymarine forum | Return to Top | Return to Content | Lite (Archive) Mode | RSS Syndication