NMEA 0183 to 2000 Conversion & Axiom

Thread Rating:

0 Vote(s) - 0 Average
1
2
3
4
5

Threaded Mode | Linear Mode

NMEA 0183 to 2000 Conversion & Axiom

04-11-17, 10:15 AM (This post was last modified: 04-11-17 10:37 AM by Chuck - Raymarine - Moderator.)

Post: #5

jkspain Offline

Junior Member

Posts: 37
Joined: Apr 2017
Reputation: 0

RE: NMEA 0183 to 2000 Conversion & Axiom

Thank-you for your detailed response.

I will proceed with the NGW-1 installation.

The output of the Raystar GPS receiver is connected to the SeaTalk connector on the Master E120 unit (Display #1). Once the NGW-1 is installed and the NMEA 0183 connection on the master unit is no longer in use, can I change the baud rate of the NMEA 0183 to 38,400 on that unit and connect it to the AIS without messing up the GPS interface?

« Next Oldest | Next Newest »

Messages In This Thread

NMEA 0183 to 2000 Conversion & Axiom - jkspain - 04-10-17, 10:54 AM

RE: NMEA 0183 to 2000 Conversion & Axiom - Chuck - Raymarine - Moderator - 04-10-17, 01:50 PM

RE: NMEA 0183 to 2000 Conversion & Axiom - jkspain - 04-10-17, 08:48 PM

RE: NMEA 0183 to 2000 Conversion & Axiom - Chuck - Raymarine - Moderator - 04-11-17, 08:31 AM

RE: NMEA 0183 to 2000 Conversion & Axiom - jkspain - 04-11-17 10:15 AM

RE: NMEA 0183 to 2000 Conversion & Axiom - Chuck - Raymarine - Moderator - 04-11-17, 10:36 AM

RE: NMEA 0183 to 2000 Conversion & Axiom - jkspain - 04-11-17, 10:08 PM

RE: NMEA 0183 to 2000 Conversion & Axiom - Chuck - Raymarine - Moderator - 04-12-17, 08:02 AM

User(s) browsing this thread: 1 Guest(s)