Post Reply 
 
Thread Rating:
  • 0 Vote(s) - 0 Average
  • 1
  • 2
  • 3
  • 4
  • 5
Vesper not talking over seatalk ng
05-15-17, 02:02 PM (This post was last modified: 05-15-17 02:16 PM by Chuck - Raymarine - Moderator.)
Post: #2
RE: Vesper not talking over seatalk ng
Welcome to the Raymarine Forum weisbergj,

Please click here to view a FAQ addressing this subject. The items within the referenced FAQ addressing NMEA 0183 networking may be skipped. It is recommended that you verify that the Data Master GPM400 (rather than a repeater GPM400) has been interfaced to the SeaTalkng backbone. Unlike the MFD designs which followed the G-Series GPM400, the SeaTalkng diagnostics of the GPM400 is quite limited. Should the other items listed within the FAQ be satisfied and should these products be interfaced to one another via a powered and properly terminated SeaTalkng / NMEA 2000 backbone, then it would be necessary to interface a NMEA 2000 network analyzer (ex. Actisense NGT-1-USB w/NMEA Reader software, etc.) to determine whether the AIS data is present on the backbone.
Visit this user's website Find all posts by this user
Quote this message in a reply
Post Reply 


Messages In This Thread
RE: Vesper not talking over seatalk ng - Chuck - Raymarine - Moderator - 05-15-17 02:02 PM

Forum Jump:


User(s) browsing this thread: 1 Guest(s)