Raymarine forum / Raymarine Forums / Instruments v / ST290 Display (E22056)

Post Reply 
 
Thread Rating:
  • 0 Vote(s) - 0 Average
  • 1
  • 2
  • 3
  • 4
  • 5
ST290 Display (E22056)
12-05-17, 11:26 AM
Post: #10
Derek - Raymarine - Moderator Offline
Administrator
*******
 		Posts: 1,416
Joined: Nov 2017
Reputation: 9
RE: ST290 Display (E22056)
Hi,
To get the biducer data onto the STng network you have two routes,
1- itc-5, connect the Biducer to the itc-5, connect itc-5 to the STng backbone and then you will need an i70 to calibrate the itc-5 to correct the boat speed and add shallow/ deep alarms

2 - i50 Bidata, connect the Biducer to the i50 Bidata - which can then be used to calibrate the Biducer and input alarms etc . . ., connect the i50 to the STng backbone, job Done.
regards
Find all posts by this user
Quote this message in a reply
Post Reply 


Messages In This Thread
ST290 Display (E22056) - ddfour1 - 11-30-17, 11:28 AM
RE: ST290 Display (E22056) - ddfour1 - 12-01-17, 02:14 PM
RE: ST290 Display (E22056) - ddfour1 - 12-04-17, 11:02 AM
RE: ST290 Display (E22056) - ddfour1 - 12-05-17, 09:52 AM
RE: ST290 Display (E22056) - Derek - Raymarine - Moderator - 12-05-17 11:26 AM
RE: ST290 Display (E22056) - ddfour1 - 12-05-17, 03:39 PM
RE: ST290 Display (E22056) - ddfour1 - 12-06-17, 10:55 AM

Forum Jump:


User(s) browsing this thread: 1 Guest(s)

Contact Us | Raymarine forum | Return to Top | Return to Content | Lite (Archive) Mode | RSS Syndication