Post Reply 
 
Thread Rating:
  • 0 Vote(s) - 0 Average
  • 1
  • 2
  • 3
  • 4
  • 5
[CA] Grand Banks 32, Axiom 9 transducer
01-31-18, 03:06 PM (This post was last modified: 02-01-18 03:33 PM by Chuck - Raymarine - Moderator.)
Post: #1
[CA] Grand Banks 32, Axiom 9 transducer
Hello,

I have a Grand Banks 32 wood boat that I recently installed an Axiom 9. I am now researching what is the correct through hull RealVision 3D transducer for this boat.

The current sonar is mounted on one side of the short keel of the boat (see picture). It had to be blocked for the last transducer to work because of the angle.

Has anybody installed a RealVision on a GB before? What is the correct transducer for through hull?

Thank you for your help.
Ray
Find all posts by this user
Quote this message in a reply
02-01-18, 03:32 PM
Post: #2
RE: [CA] Grand Banks 32, Axiom 9 transducer
Welcome to the Raymarine Forum Ray,

Bronze thru-hulls are recommended for use with wooden hulls. The hull's deadrise in the location where the transducer will be installed will need to be measured. A RV-212 transducer pair would be recommended for deadrise angles from 1° to 12°. The RV-220 transducer pair would be recommended for deadrise angles from 13° to 20°.
Visit this user's website Find all posts by this user
Quote this message in a reply
Post Reply 


Forum Jump:


User(s) browsing this thread: 1 Guest(s)