Post Reply 
 
Thread Rating:
  • 0 Vote(s) - 0 Average
  • 1
  • 2
  • 3
  • 4
  • 5
[CA] Axiom 7 and i60 wind system
03-19-18, 09:30 PM (This post was last modified: 03-20-18 04:06 PM by Chuck - Raymarine - Moderator.)
Post: #1
[CA] Axiom 7 and i60 wind system
Hello,

I just installed an Axiom 7 and i60 wind system on a sailboat.

I built a Stng network using an E22158 (to integrate existing ST1 speed/depth). The i60 shows as a source of wind data in the Axiom data sources utility and the E22158 shows as a source for speed and depth data.

I am unable to find how to turn on the wind vector on the Axiom display. I think I've exhausted all the menu options and cannot find it.

Please help.

Thanks, Keith
Find all posts by this user
Quote this message in a reply
03-20-18, 04:06 PM (This post was last modified: 03-20-18 04:07 PM by Chuck - Raymarine - Moderator.)
Post: #2
RE: [CA] Axiom 7 and i60 wind system
Welcome to the Raymarine Forum Keith,

To access the configuration settings for vectors, hold you finger pressed to the vessel position icon shown on the screen of the Chart application. Doing so will display the vessel menu, from which the operator may select to display vectors as well as configure their lengths. This menu will also permit the wind arrow to be displayed.
Visit this user's website Find all posts by this user
Quote this message in a reply
Post Reply 


Forum Jump:


User(s) browsing this thread: 1 Guest(s)