Post Reply 
 
Thread Rating:
  • 0 Vote(s) - 0 Average
  • 1
  • 2
  • 3
  • 4
  • 5
[TG11] Use Type 3 Hydraulic Pump With a 255 cm3 Cylinder
05-31-18, 11:20 PM
Post: #6
RE: [TG11] Use Type 3 Hydraulic Pump With a 255 cm3 Cylinder
It's difficult to give a realistic idea of average consumption because there are so many variables:

Factors which affect the load on the drive:
- boat weight
- rudder size
- internal steering resistance and losses
- sail trim
- sea-state and wind-speed
- point of sail
Factors which affect how frequently the pilot has to drive:
- sail trim
- sea-state and wind-speed
- point of sail
- pilot response level and calibration
- ...

We don't attempt to take all of these into account in order to come up with an average consumption over time. As a very rough guesstimate, though, I'd say that if your drive is averaging anything more than 10-15% of the peak current over time, you have something badly wrong in your setup or sail-trim.

Regards,
Tom

Raymarine since 1999.
Interests: Diagnosis of problems in sonar/fishfinders, NMEA2000, ethernet comms, autopilots, thermal cameras
Location: Sydney, Australia.

Please don't PM me asking for direct support, please ask a public question instead so that others can see the question and answer. Forum posts will always be answered before PM requests.
Find all posts by this user
Quote this message in a reply
Post Reply 


Messages In This Thread
RE: [TG11] Use Type 3 Hydraulic Pump With a 255 cm3 Cylinder - Tom - Raymarine - Moderator - 05-31-18 11:20 PM

Forum Jump:


User(s) browsing this thread: 1 Guest(s)