Raymarine forum / Raymarine Forums / Autopilots v / [CA] [CA11] Connection wiring too short

Post Reply 
 
Thread Rating:
  • 0 Vote(s) - 0 Average
  • 1
  • 2
  • 3
  • 4
  • 5
[CA] [CA11] Connection wiring too short
08-01-18, 08:17 AM (This post was last modified: 08-03-18 01:36 PM by Chuck - Raymarine - Moderator.)
Post: #1
WEG3 Offline
Junior Member
**
 		Posts: 8
Joined: Jul 2017
Reputation: 0
[CA11] Connection wiring too short
I’m installing a new EV-100 Wheel Auto Pilot along with Sea Talk, ACU etc. I’m finding that preferred placement of the controller from the EV-1 sensor, Drive unit and power supply is further than the supplied power lines and Sea Talk cables will allow. Is it possible to get longer lines? If so, what part numbers should I use in ordering?
Find all posts by this user
Quote this message in a reply
08-03-18, 01:43 PM (This post was last modified: 08-03-18 01:44 PM by Chuck - Raymarine - Moderator.)
Post: #2
Chuck - Raymarine - Moderator Offline
Administrator
*******
 		Posts: 14,319
Joined: Oct 2014
Reputation: 43
RE: [CA11] Connection wiring too short
Welcome to the Raymarine Forum WEG3,

Please click here to view a FAQ addressing installation of products in conjunction with a pedestal. The maximum permissible length of a SeaTalkng/NMEA 2000 spur is 6m. Should the separation distances of devices exceed this maximum, then the SeaTalkng backbone will need to be extended to close the distance. SeaTalkng networking components may be found on Raymarine’s SeaTalkng / NMEA 200 Networking web page.
Find all posts by this user
Quote this message in a reply
Post Reply 


Forum Jump:


User(s) browsing this thread: 1 Guest(s)

Contact Us | Raymarine forum | Return to Top | Return to Content | Lite (Archive) Mode | RSS Syndication