Post Reply 
 
Thread Rating:
  • 0 Vote(s) - 0 Average
  • 1
  • 2
  • 3
  • 4
  • 5
[CA] [CA11] E120 Seatalk1 to NMEA 2000 conversion requirements
08-21-18, 07:56 AM
Post: #8
RE: [CA11] E120 Seatalk1 to NMEA 2000 conversion requirements
Bruce,

Q1. The Seatalk devices list has a line with a device ID but no NAME
5) Unknown device ID = 208D v2.04 (I suspect it is the GPS antenna). Would this be consistent with an RC120 or other Raymarine GPS receiver - If not, is there ANY association between the ID and a device type or class?
A1. Unfortunately, I cannot identify the device via the product's hexadecimal ID. The only way to be certain as to what the device is would be to temporarily disconnect it from the SeaTalk bus (disconnect the sensor's SeaTalk data lead (yellow) for the terminal strip). Should the Unknown device ID = 208D v2.04 no longer be listed within the SeaTalk devices list, then you can safely assume that Unknown device ID = 208D is your GPS sensor.

Q2. Based on the discussion so far, I think I can conclude that the device is a Seatalk device - TRUE?
A2. Correct.

A3. If so, the software uorae should work without any network reconfiguration -(likely)TRUE ??
A3. Correct.
Find all posts by this user
Quote this message in a reply
Post Reply 


Messages In This Thread
RE: [CA11] E120 Seatalk1 to NMEA 2000 conversion requirements - Chuck - Raymarine - Moderator - 08-21-18 07:56 AM

Forum Jump:


User(s) browsing this thread: 2 Guest(s)