[CA11] Using legacy seatalk power supply for STng backbone

Thread Rating:

0 Vote(s) - 0 Average
1
2
3
4
5

Threaded Mode | Linear Mode

[CA] [CA11] Using legacy seatalk power supply for STng backbone

10-15-18, 10:28 AM

Post: #4

Chuck - Raymarine - Moderator Offline

Administrator

Posts: 14,319
Joined: Oct 2014
Reputation: 43

RE: [CA11] Using legacy seatalk power supply for STng backbone

Richard,

When properly installed, the SeaTalkng backbone (via the ST-STng Converter) should be supplying power to the SeaTalk bus. If disconnecting power the SeaTalk bus now prohibits your instruments from powering ON, then there would appear to be a fault with your installation. Please attach a system diagram (a photo of a hand drawn diagram will suffice) to a response to this thread for further analysis. The diagram should show each device and how it has been interfaced to the system.

« Next Oldest | Next Newest »

Messages In This Thread

[CA11] Using legacy seatalk power supply for STng backbone - riclevitt - 10-12-18, 08:24 AM

RE: [CA11] Using legacy seatalk power supply for STng backbone - Chuck - Raymarine - Moderator - 10-12-18, 09:23 AM

RE: [CA11] Using legacy seatalk power supply for STng backbone - riclevitt - 10-14-18, 06:06 PM

RE: [CA11] Using legacy seatalk power supply for STng backbone - Chuck - Raymarine - Moderator - 10-15-18 10:28 AM

RE: [CA11] Using legacy seatalk power supply for STng backbone - riclevitt - 10-20-18, 04:46 PM

RE: [CA11] Using legacy seatalk power supply for STng backbone - Chuck - Raymarine - Moderator - 10-22-18, 12:47 PM

RE: [CA11] Using legacy seatalk power supply for STng backbone - riclevitt - 11-04-18, 07:33 PM

RE: [CA11] Using legacy seatalk power supply for STng backbone - Chuck - Raymarine - Moderator - 11-05-18, 08:51 AM

User(s) browsing this thread: 1 Guest(s)