Post Reply 
Thread Rating:
  • 0 Vote(s) - 0 Average
  • 1
  • 2
  • 3
  • 4
  • 5
SD 50+ depth calibration
05-04-16, 07:51 AM (This post was last modified: 05-04-16 07:51 AM by Steve - Raymarine - Moderator.)
Post: #2
RE: SD 50+ depth calibration
That isn't correct. The depth transducer is made up of elements that output and receive the sonar signal. If you are noticing decreased performance, this is due to the elements inside the transducer are degrading or you are losing elements. The recommended course of action is replacing the transducer. Current instrument Depth Transducers are compatible with the ST50+ Depth displays. You will need to cut the transducer connector off the ST50+ display, then remove the spade connectors off the current depth transducers and splice color for color to connect.
Find all posts by this user
Quote this message in a reply
Post Reply 

Messages In This Thread
SD 50+ depth calibration - SvAndante - 04-30-16, 03:49 PM
RE: SD 50+ depth calibration - Steve - Raymarine - Moderator - 05-04-16 07:51 AM

Forum Jump:

User(s) browsing this thread: 1 Guest(s)