The following warnings occurred:
Warning [2] count(): Parameter must be an array or an object that implements Countable - Line: 802 - File: showthread.php PHP 7.4.33 (Linux)
File Line Function
/showthread.php 802 errorHandler->error




Raymarine forum / Raymarine Forums / Radar v / Radar -- no data source followed by operation

Post Reply 
 
Thread Rating:
  • 0 Vote(s) - 0 Average
  • 1
  • 2
  • 3
  • 4
  • 5
Radar -- no data source followed by operation
05-02-16, 11:06 AM
Post: #1
michaellutz Offline
Junior Member
**
 		Posts: 8
Joined: Feb 2016
Reputation: 0
Radar -- no data source followed by operation
Something has changed. My radar and E-120 are 9 years old. Previously when I switched on the E0120 the radar went into operation quickly. Now I find when I switch it on that it reads "No data source". Then if I wait anywhere from a few seconds to 10 minutes, it comes alive. Electrical system is normal. Is this a symptom of failing electronics? And where is the electronics? In the scanner itself? What should I try because it is intermittent. Thanks.
Find all posts by this user
Quote this message in a reply
Post Reply 


Messages In This Thread
Radar -- no data source followed by operation - michaellutz - 05-02-16 11:06 AM

Forum Jump:


User(s) browsing this thread: 1 Guest(s)

Contact Us | Raymarine forum | Return to Top | Return to Content | Lite (Archive) Mode | RSS Syndication