[TG] [TG11] ST60+ Low Depth Alarm Setting Blocked?

[Derek - Raymarine - Moderator]

Hi Dave,

Given the Depth Transducer is connected to the ST60+ depth display, the Shallow depth alarm can only be edited through that specific display. Alarm settings in other displays should not affect this at all.

Check the Alarm settings for the Anchor alarm too, this has both shallow and deep alarms too and sometimes this gets confused with the shallow alarm.

Can you change the KEEL/ WATERLINE offset? If not, then is the ST60+ set as MASTER? If it is set as MASTER and you cannot change any of the calibration, is CAL LOCK on? If CAL LOCK is OFF, then the ST60+ depth sounds like it may be faulty?

The Graphic cannot be used to set the alarms - these are only settable in the display which is connected to the transducer.

As far as I can see, the drawing looks good, the only point i would raise is that the SeaTalk1 instruments should not be powered through the converter, the yellow wire connecting the Converter block for STng should be opened up and the red internal wire cut and insulated - the SeaTalk1 should be powered directly themselves and not through the converter block. Powering the converter block from both SeaTalk1 and STng is not advised and so there should be power to the SeaTalk1 system and power to STng.

Thanks
Derek