The following warnings occurred:
Warning [2] count(): Parameter must be an array or an object that implements Countable - Line: 802 - File: showthread.php PHP 7.4.33 (Linux)
File Line Function
/showthread.php 802 errorHandler->error





Post Reply 
 
Thread Rating:
  • 0 Vote(s) - 0 Average
  • 1
  • 2
  • 3
  • 4
  • 5
HI I need a diagram for my new Raymarine system
05-09-16, 09:41 AM
Post: #1
HI I need a diagram for my new Raymarine system
OKay,

I've got the;

Raymarine E7d Radar Pack W/Noaa Vector Chart Rd418d Dome (Still in box)
Raymarine Ev-200 Sail Linear Drive Evolution Autopilot (Still in box)
an old ICOM VHF (Installed at chart table)
A new standard horizon GX2200 (Still In Box)
i50/60 Instruments wind/speed/depth/ installed by PO last July next to companionway on bulkhead.
(these were installed very shoddy. speed and depth are Daisy chained together.
There is the beginnings of a backbone a one-meter backbone cable and Two tees.
They left the unused branches of the tees open with no terminators. The wind
instrument is powered separately, and is on the opposite side of the
companionway. This is not connected to the other two instruments. The speed
and depth instruments are to Port and the wind instrument is to starboard of the
companionway. There is a 1 meter backbone cable running between the two T's
the power is into one tee and the instruments are on the other tee.)

The boat is a 1985 Tartan 40 with the radome up the mast
I have 3 group 27 batteries under the forward berth and one starting battery under the cockpit.

It is basically all new Raymarine install, Instruments, Chart Plotter, Radar, AP and new Standard Horizon GX2200. There are some old instruments but I'm thinking I'm going to rip those out.
Find all posts by this user
Quote this message in a reply
Post Reply 


Messages In This Thread
HI I need a diagram for my new Raymarine system - SloopDogg - 05-09-16 09:41 AM

Forum Jump:


User(s) browsing this thread: 1 Guest(s)